Product Description; Intended Use; Use Not In Accordance With The Intended Use; Ec-Declaration Of Conformity - GF 514 Betriebsanleitung

Diaphragm valve type 514, 515, 517, 519
3

Product description

3.1

Intended use

Diaphragm valves type 514, 515, 517 and 519 are exclusively intended to be installed in a compatible industrial piping system to shut
off, pass or control the flow of approved media.
3.2

Use not in accordance with the intended use

Any use other than that described in the intended use is not in accordance with the intended use and is therefore not permitted. If
unsuitable products are installed or used in safety-relevant applications, unintended operating conditions may occur in the applica-
tion that can cause personal injury and/or property damage. Only use the product in safety-relevant applications if this use is ex-
pressly specified and permitted in the product documentation.
Georg Fischer Piping Systems Ltd. accepts no liability for damage resulting from improper use. The risks associated with improper
use lie solely with the user.
3.3

EC-Declaration of conformity

The manufacturer Georg Fischer Rohrleitungssysteme AG, 8201 Schaffhausen (Switzerland) declares that the industrial valves
listed below are pressure-maintaining equipment in the sense of the EC Pressure Equipment Directive 2014/68/EU, Category I,
Module A, according to the listed harmonized design standards, and comply with such requirements of this Directive as apply to
industrial valves. The CE marking on the industrial valves indicates this conformity.
According to the Pressure Equipment Directive (Art. 4, Par. 3), industrial valves whose DN is less than or equal to 25 may not bear
the CE marking. The putting into operation of these industrial valves is prohibited until the conformity of the entire system, in which
the industrial valves are installed, with the above-mentioned EC Directive has been declared.
Modifications which affect the stated technical data and the intended use render this declaration of conformity or manufacturer's
declaration invalid.
Additional information can be found in the "GF Planning Fundamentals Industry".
Product group
Thermoplastic diaphragm valves
Schaffhausen, December 1, 2021
Bastian Lübke
Head of Global R&D
Georg Fischer Piping Systems Ltd.
CH-8201 Schaffhausen (Switzerland)
10
Type designation
514, 515, 517, 519
Operating Instructions
Additional directives and harmonized de-
sign standards
EN ISO 16138