Switching The Product Off; Cleaning And Storage; Troubleshooting - Parkside PAS 2800 A1 Bedienungs- Und Sicherheitshinweise

It is, therefore, not suitable for continuous
operation�
RISK OF ELECTRIC SHOCK! Only
charge the product in dry, interior
rooms, as the splash water
protection (IPX4) cannot be guaranteed
when the charging cable is connected.
Do not carry the product during charging.
„
Open the USB cover
„ „
charging socket
12
the USB-C charging cable provided
fig A) into the USB-C charging socket of the
product.
To charge the battery, connect the USB-C
„ „
charging cable
6
(SELV - 5 V, max. 1 A, not included).
Plug the USB mains adaptor into a power
„ „
outlet�
All LEDs in the charge indicator
„ „
start flashing. The battery will start
charging. The more LEDs light up
continuously, the higher the charge status of
the battery.
When the product is fully charged, all of
„ „
the LEDs will remain constantly on.
You can now unplug the USB mains
„ „
adaptor from the socket and the charging
cable from the product.
Place the USB cover
„ „
again to protect the product from humidity
and ensure splash water protection.
z Switching the product off
Press the ON/OFF switch
„ „
product off.
Alternatively, you can fold the LED panels
„ „
inwards.
3
46
GB/IE/NI/CY/MT
of the USB
10
(see fig. D) and plug
(see
6
to a USB mains adaptor
will
8
over the jack
10
to switch the
11
z Cleaning and storage
RISK OF DAMAGE! Cleaning the
product incorrectly can potentially
cause damage.
Do not use chemicals for cleaning.
„
Use only a dry, lint-free cloth for cleaning. If
„
the product is very dirty, dampen the cloth
slightly.
To prevent a short circuit or other damage,
„
the USB-C charging socket must not come
in contact with moisture during the cleaning
process.
When the product is not in use, store inside
„
the packaging in a dry place.
To maintain the rechargeable battery's
„
capacity, it needs to be charged for about
2 hours about every 4 months.
z Troubleshooting
= Fault
= Cause
= Solution
= The product fails to switch on.
= The product is switched off.
= Press the ON/OFF switch
switch the product on.
= The light is flickering.
= The battery is almost fully discharged.
= Charge the battery (see section
"Charging the battery").
to
11