Preparation Before Use - Dreame Bot D9 Max Benutzerhandbuch

EN

Preparation Before Use

1. Remove the protective film
Remove the protective films on the robot.
2. Install the side brush
Click
Note: Install the side brush until it clicks into place.
8
3. Place the charging dock on the level ground
against the wall and connect it to a power outlet
＞ 0.5 m Tidy up Any
Loose Cord
＞ 1.5 m ＞ 0.5 m
Note:
• Keep the immediate area 1.5m in front of the charger and 0.5m to both
sides of the charging dock clear of objects.
• To ensure you can connect to the robot with your phone well, make sure
the robot and charging dock are within the range of Wi-Fi.
• Do not place the charging dock in an area with direct sunlight or where
other objects might block the signal, as this may hinder the robot from
returning to the charging dock.
4. Place the robot onto the charging dock to
recharge. The robot will turn on automatically and
begin recharging
Battery Level Indicator
• White: Battery level
is more than 15%
• Orange: Battery
level is less than 15%
Note:
• Fully charge your robot before first-time use.
• Don't install the mopping module while charging. Be extra careful with
wet mop as it can damage the floor.
Connecting with Mi Home/Xiaomi Home App
This product works with the Mi Home/Xiaomi Home app. * Use the Mi Home/Xiaomi Home app to control your device and to interact with
other smart home devices.
1. Download the Mi Home/Xiaomi Home App
Scan the QR code to download and install the app. You will be
directed to the connection setup page if the app has been installed
already. Alternatively, search "Mi Home/Xiaomi Home" in the app
store to download and install it.
2. Add Device
Open the Mi Home/Xiaomi Home app, and tap " " in the upper
right. Then tap " " in the top right corner, scan the QR code,
add "Dreame Bot D9 Max", and follow the prompts to finish the
connection.
xxxxxxx' home
No home environment info
Scanning for devices nearby...
What should I do if I cannot scan for
Devices Rooms
devices?
Note:
• Only 2.4GHz Wi-Fi is supported.
• The version of the app might have been updated. Please follow the
instructions based on the current app version.
3. Reset Wi-Fi
Simultaneously press and hold the buttons and until
you hear a voice say, "Waiting for the network configuration."
Once the Wi-Fi indicator is blinking slowly, the Wi-Fi has been
successfully reset.
Wi-Fi Indicator
• Blinking slowly: To be
connected
• Blinking quickly:
Connecting
• On: Wi-Fi connected
Note: If your robot cannot connect to the app successfully, reset the Wi-Fi
and add the device again.
EN
9