EN
13
Connect the earthing (hexagon key size 5,
long-nose pliers).
✓ Note the sequence: serrated lock
washer, terminal lug, washer.
✓ Note the alignment of the terminal lug.
14
Press the terminals together (long-nose
pliers) and connect the cable to the printed
circuit assembly (long-nose pliers).
50
15
Insert the sensor cable.
The earthing cable must not be clamped
under the control electronics. Ensure that
the cable routing is neat.
16
Put on the printed circuit assembly and
tighten the screws (Torx® profile T10).
17
Insert the light pipe with the flat side facing
upwards.
10417165195 © 12-2022
971.328.00.0(00)