Minute Minder; Power Management - Electrolux DMSL8340AO Benutzerinformation

14 www.electrolux.com
To change the time: select the cooking
zone with
To deactivate the function: select the
cooking zone with
remaining time counts back to 00.
The timer finishes counting down, a
signal sounds and 00 blinks. The cooking
zone deactivates. Press any symbol to
stop the signal and blinking.

Minute Minder

1. Press
2. Press
The timer finishes counting down, a
signal sounds and 00 blinks. Press any
symbol to stop the signal and blinking.
To deactivate the function: press
and . The remaining time counts back
to 00.

5.8 Power management

If multiple zones are active and the
consumed power exceeds the limitation
of the power supply, this function divides
the available power between all cooking
zones (connected to the same phase).
The hob controls heat settings to protect
the fuses of the house installation.
• Cooking zones are grouped according
to the location and number of the
phases in the hob. Each phase has a
maximum electricity loading. If the
hob reaches the limit of maximum
available power within one phase, the
power of the cooking zones will be
automatically reduced.
• The heat setting of the cooking zone
selected first is always prioritised. The
remaining power will be divided
between the previously activated
cooking zones according to the order
of selection.
• For cooking zones that have a
reduced power, the control bar blinks
and shows the maximum possible
heat settings.
• Wait until the display stops flashing or
reduce the heat setting of the cooking
zone selected last. The cooking zones
will continue operating with the
and press or .
and press
.
or to set the time.
reduced heat setting. Change the
heat settings of the cooking zones
manually, if necessary.
• The hood extractor is always available
as an electrical load.
. The
Refer to the illustration for possible
combinations in which power can be
distributed among the cooking zones.
5.9 Hood functions
WARNING!
Refer to Safety chapters.
Activating and deactivating the
hood
The hood can operate alongside the hob
during the cooking session, as well as
while the hob is switched off.
1. Press one of the fan speed levels
(1-3) on the hood control bar to
activate the hood.
A signal sounds and indicators above the
hood control bar appear.
2. Adjust the fan speed setting as
needed by pressing either of the
available levels on the hood control
bar.
3. To deactivate the hood, press 0 on
the hood control bar.
The indicators above the hood control
bar disappear.
AUTO
The function automatically adjusts the
fan speed level based on the selected
heat setting level of the hob.