Electrolux DMSL8340AO Benutzerinformation Seite 26

26 www.electrolux.com
9.1 What to do if...
Problem
You cannot activate or
operate the hob.
You can hear a constant
beep noise.
You cannot select the
maximum heat setting
for one of the cooking
zones.
An acoustic signal
sounds and the hob de‐
activates.
An acoustic signal
sounds when the hob is
deactivated.
The hob deactivates.
Residual heat indicator
does not come on.
There is no sound when
you touch the panel sen‐
sor fields.
Possible cause
The hob is not connected
to an electrical supply or it
is connected incorrectly.
The fuse is blown.
You did not set the heat
setting for 60 seconds.
You touched 2 or more
sensor fields at the same
time.
Pause operates.
There is water or fat stains
on the control panel.
The electrical connection is
incorrect.
The other zones consume
the maximum available
power.
Your hob works properly.
You put something on one
or more sensor fields.
You put something on the
sensor field .
The zone is not hot be‐
cause it operated only for a
short time or the sensor is
damaged.
The sounds are deactiva‐
ted.
Remedy
Check if the hob is correctly
connected to the electrical
supply.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
Activate the hob again and
set the heat setting in less
than 60 seconds.
Touch only one sensor field.
Refer to "Pause".
Clean the control panel.
Disconnect the hob from the
electrical supply. Ask a quali‐
fied electrician to check the
installation.
Reduce the heat setting of
the other cooking zones con‐
nected to the same phase.
Refer to "Power manage‐
ment".
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the zone operated suffi‐
ciently long to be hot, speak
to an Authorised Service
Centre.
Activate the sounds. Refer to
"Daily use".