Countdown-Timer; Minute Minder; Power Management - Electrolux DMGL8312AO Benutzerinformation

directly in the bottom of the cookware.
The glass ceramic is heated by the heat
of the cookware.
The indicators appear when a cooking
zone is hot. They show the level of the
residual heat for the cooking zones you
are currently using:
- continue cooking,
- keep warm,
- residual heat.
The indicator may also appear:
• for the neighbouring cooking zones
even if you are not using them,
• when hot cookware is placed on cold
cooking zone,
• when the hob is deactivated but the
cooking zone is still hot.
The indicator disappears when the
cooking zone has cooled down.
6.7 Timer
Count Down Timer
Use this function to specify how long a
cooking zone should operate during a
single cooking session.
Set the heat setting for the selected
cooking zone and then set the function.
1. Press . 00 appears on the timer
display.
2. Press or to set the time (00-99
minutes).
3. Press to start the timer or wait 3
seconds. The timer begins to count
down.
To change the time: select the cooking
zone with and press
To deactivate the function: select the
cooking zone with
remaining time counts back to 00.
The timer finishes counting down, a
signal sounds and 00 blinks. The cooking
zone deactivates. Press any symbol to
stop the signal and blinking.
or .
and press . The

Minute Minder

You can use this function when the hob
is activated but the cooking zones do not
operate. The heat setting shows 00.
1. Press .
2. Press or to set the time.
The timer finishes counting down, a
signal sounds and 00 blinks. Press any
symbol to stop the signal and blinking.
To deactivate the function: press
and . The remaining time counts back
to 00.

6.8 Power management

If multiple zones are active and the
consumed power exceeds the limitation
of the power supply, this function divides
the available power between all cooking
zones. The hob controls heat settings to
protect the fuses of the house
installation.
• If the hob reaches the limit of
maximum available power (refer to
the rating plate), the power of the
cooking zones will be automatically
reduced.
• The heat setting of the cooking zone
selected first is always prioritised. The
remaining power will be divided
between the previously activated
cooking zones according to the order
of selection.
• For cooking zones that have a
reduced power, the control bar blinks
and shows the maximum possible
heat settings.
• Wait until the display stops flashing or
reduce the heat setting of the cooking
zone selected last. The cooking zones
will continue operating with the
reduced heat setting. Change the
heat settings of the cooking zones
manually, if necessary.
• The hood extractor is always available
as an electrical load.
6.9 Hood functions
WARNING!
Refer to Safety chapters.
ENGLISH 15