Electrolux DMSL8340AO Benutzerinformation Seite 20

20 www.electrolux.com
FlexiBridge Max Bridge mode
To activate the mode press
see the correct mode indicator
mode connects all sections into one
cooking area. To set the heat setting use
any of the two control bars on the left
side.
Correct cookware position:
Make sure to place the cookware on the
four connected sections. If you use
cookware smaller than three sections the
control bar blinks and after 2 minutes the
zone switches off.
Incorrect cookware position:
until you
. This
PowerSlide
This function allows you to adjust the
temperature by moving the cookware to
a different position on the induction
cooking area.
• The function divides the induction
cooking area into three areas with
different heat settings. The hob
detects the position of the cookware
and adjusts the heat setting
corresponding with the position.
• You can place the cookware in the
front, middle or rear position. If you
place the cookware in the front you
get the highest heat setting. To
decrease it, move the cookware to
middle or rear position.
• When you activate the function for the
first time you will get the following
default heat settings: 9 for the front
position, 6 for the middle position and
3 for the rear position.
• You can change the heat settings for
each position separately. The hob will
remember your heat settings next
time you activate the function.
• The heat setting display of the left
front control bar shows the heat
setting for this function. To change
the heat setting use the left front
control bar only. The left rear control
bar is deactivated while the function
operates.
In some models there are
two flexible cooking areas,
left and right. To operate
PowerSlide on the right side,
use the right front control
bar.