Energy Efficient Usage - Grundig GDT 2561 X Bedienungsanleitung

OPERATION OF THE APPLIANCE ______________________
Controlling the Appliance
A B
A. Press this button to turn on the appliance, the
product will operate at speed level 1, when this
button is pressed.
B. The product will operate at speed level 2, when
this button is pressed.
C. By exploring the display, you may follow which
speed the product operates at on it.
D. The product will operate at booster level, when
this button is pressed.
E. Press this button to switch the lamp on and off.
NOTE: By pressing and holding any engine
operating button for more than 2 seconds, a 15
minutes timer function will be initiated. A signal
will be displayed as soon as the chronometer
starts, and the engine will automatically stop after
15 minutes.

Energy Efficient Usage

Your new appliance is exclusively
designed for energy saving. here
C
you may find several recommen-
dations on how to save more ener-
gy while using your appliance and
several devices necessary for using
your appliance appropriately.
Make sure that there is an adequate air inlet
■
to allow your product to operate efficiently and
with a low operating noise.
Adjust the fan speed according to the intensity
■
of the vapors in the kitchen. use the intense
8 ENGLISH
C D E
settings only if needed. a lower fan speed set-
ting means lower energy consumption.
If there is a high amount of smoke in the kitchen,
■
select a higher fan speed. the hood must oper-
ate for a longer period in order to eliminate the
smoke already spread in the kitchen.
Turn off the hood when not in use.
■
Clean or replace the filter within the specified
■
time intervals in order to increase the efficiency
of ventilation and to avoid a fire hazard.
Cleaning Time for the Metal Filter:
Filters must be cleaned when the signal „c" is dis-
played on the screen or (depending on the use)
after 3 or 4 weeks. In order to clear the "c" signal,
after the filters have been cleaned and replaced,
press and hold the button (A) for more than 3 sec-
onds (when the device is turned off). the letter "e"
will appear on the screen, and the appliance will
operate normally. if operations are necessary be-
fore clearing the letter "c", then the active engine
speed will appear for 1 second when you press
the (A) button and then the engine will resume
functioning.
C
The "c" symbol will be displayed af-
ter 60 hours of functioning.