KLIM Ai-1 Airbag Vest Benutzerhandbuch Seite 8

not discard a full inflator (that has never been triggered). In the
event your inflator has surpassed its life expectancy (4 years for
expiry date as printed on the label) you are required to recycle
this inflator as a full inflator is never to be disgarded as it must
be recyled. Please contact In&Motion at www.inemotion.com
for further recycling details. Check if the inflator is full or empty:
• Screw the inflator into the In&motion airbag system • Plug the
connector into the inflator
• Insert the running In&box into its housing
If the inflator LED (light indicator) is solid green, the
inflator is full and connected.
If the inflator LED (light indicator) is solid red, the inflator
is empty and/or improperly connected.
BACK PROTECTOR:
The vest contains a back protector certified EN
1621-2:2014. The In&motion back protector has been
designed specifically for two-wheeled motor vehicle
users and must be used exclusively in association with
the In&motion airbag system.
Ai-1 airbag vest contains a IMP Moto 1 back protector.
You will find its user manual on page xxx of this manual.
Ai- 1 Rally Vest contains a D3O back
and chest protector. See the D3O
user manual provided with the D3O
back and chest protector.
INFLATOR REPLACEMENT (O)
Warning! Do not touch the full inflator connector with your fingers
(blue piece on the bottom of the inflator). Do not connect the
inflator connector to the inflator before having screwed it on the
cushion.
1. Replacing the inflator
Warning, inflators are for single-use. After an inflation, it cannot
be refilled and must be changed. Only inflators provided by
In
In
re
T
2
A
1)
2
3
4
T
d
Y
a
h
In
3
C
p
C
a
in
w
ru
lo
4
W
T
W
re
fo
e
R