KLIM Ai-1 Airbag Vest Benutzerhandbuch Seite 11

6. Install a new inflator
Warning! Do not touch the full inflator connector with your fingers
(blue piece on the bottom of the inflator). Do not connect before
having screwed on the inflator.
Warning! Before carrying out the following
steps, check that the airbag system is
completely void of air.
Screw on the new inflator hand tight.
Plug the connector back in.
Check that it is properly clipped all the way.
Clip the inflator into its housing.
Check that the inflator is correctly positioned,
fully seated in its housing.
Close the zipper to the top.
To check that the inflator is new and properly
connected, take the In&box, put it on and insert in its
housing. The inflator LED should switch to green.