Rectifying Malfunctions - Geberit ESG LIGHT Betriebsanleitung

Rectifying malfunctions

If the Malfunction LED display
display light up, the welding process has been aborted prematurely because of a malfunction.
Malfunction
Malfunction and Mains
connection LED displays
light up.
Malfunction and
Welding procedure LED
displays light up.
Malfunction and
Welding complete LED
displays light up.
Malfunction and Ready
for welding LED displays
light up.
Malfunction , Welding
procedure and Ready
for welding LED displays
light up.
63050397048849803 © 02-2023
967.778.00.0(02)
lights up or the Malfunction LED display
Cause
Mains voltage too low.
Mains voltage too high.
Defective Geberit electrofusion
coupling or defective Geberit
electrofusion tape for anchor
point.
Sleeve connection plug
removed during the welding
procedure.
Electrofusion tool is
overheating or operating at too
high an ambient temperature.
Operating at too low an
ambient temperature.
Fault current while welding,
e.g. as a result of moisture on
electrical connections.
plus another LED
Rectification
▶ Switch off any non-essential
consumers.
▶ Disconnect the mains plug
and contact the power
supplier.
▶ Disconnect the mains plug.
▶ Carry out a visual inspection
of the contacts on the
sleeve connection plugs and
dry or clean them if
necessary.
▶ Use a new Geberit electro-
fusion coupling or a new
Geberit electrofusion tape
for anchor point.
▶ Disconnect the mains plug.
▶ Press the start button and
hold for three seconds.
▶ Repeat the welding
procedure with a cooled
Geberit electrofusion
coupling or cooled Geberit
electrofusion tape for
anchor point.
▶ Let electrofusion tool cool
down until the trouble
indication goes out.
▶ Do not expose the electro-
fusion tool to direct sunlight.
▶ Only operate the electro-
fusion tool in the permitted
temperature range. For
more information, see
chapter "Technical data",
page 21.
▶ Disconnect the mains plug.
▶ Keep electrofusion tool, all
cables as well as Geberit
electrofusion coupling or
Geberit electrofusion tape
for anchor point dry and
clean.
EN
25