Geberit ESG LIGHT Betriebsanleitung Seite 22

EN
Operation
Welding with the Geberit
ESG Light electrofusion tool
The Geberit ESG Light electrofusion
tool is equipped with an automatic
mechanism which prevents a double
weld when a coupling connection
cable is connected.
The required welding time is adjusted
automatically in accordance with the
ambient temperature.
Prerequisite
– Pipes, fittings and welding joints are dry
and free of dirt.
– Pipes and fittings are prepared in
accordance with the installation manual
for Geberit electrofusion sleeve
couplings.
– Pipe surfaces are prepared in
accordance with the installation manual
for Geberit electrofusion tape for anchor
point.
22
WARNING
Danger of death from electric
shock
▶ Do not weld wet or water-
filled pipes.
▶ An isolation transformer
must be included in the
circuit when carrying out
electrofusion work in damp
areas.
CAUTION
Risk of injury from burns
▶ Do not touch the
electrofusion sleeve
coupling or electrofusion
tape, plug contacts and pipe
during the welding
procedure or during the
cooling-down phase.
ATTENTION
Leaking connection caused by faulty
welding
▶ The pipe to be welded must be kept in
a tension-free position during the
welding procedure and the cooling-
down phase.
▶ Air draughts through the pipe interior
must be avoided.
63050397048849803 © 02-2023
967.778.00.0(02)