Malfunctions During Operation - Geberit ESG 3 Betriebsanleitung

EN

Malfunctions during operation

If the general malfunction LED display
malfunction LED display
welding process has been aborted prematurely because of a
malfunction.
Disconnect the mains plug so that the trouble indication goes out
and the malfunction can be corrected.
Fault
LED displays
for general
malfunction
and mains
connection
light up
LED displays
for general
malfunction
and welding
process
light up
36
plus another LED display light up, the
Cause
Malfunction due to
undervoltage
Malfunction due to
overvoltage
Malfunction on the
Geberit electrofusion
sleeve coupling or the
Geberit electrofusion
tape for anchor point
during welding
lights up or the general
Actions
Disconnect other
devices from the
power supply system
Use an emergency
generator unit with a
higher power
Connect additional
consumers to the
power supply system
or the emergency
generator unit
Check the contacts on
the sleeve connection
cable
Use a new Geberit
electrofusion sleeve
coupling or a new
Geberit electrofusion
tape for anchor point
B1157-001 © 02-2014
966.475.00.0 (00)