Rectifying Malfunctions - Geberit ESG light Betriebsanleitung

EN
Aborting the welding procedure
with the Geberit electrofusion
machine ESG light
1
To cancel the welding procedure,
press the start button.
ü Welding procedure LED display
2
Unplug both sleeve connection plugs.
ü Malfunction LED display
flashes.

Rectifying malfunctions

If the Malfunction LED display
display light up, the welding process has been aborted prematurely because of a malfunction.
Malfunction
Malfunction
connection LED displays
light up
24
1
goes out.
lights up or the Malfunction LED display
Cause
Mains voltage too low
and Mains
Mains voltage too high
3
Press the start button and hold for
three seconds.
ü Malfunction LED display
out.
Result
ü The welding procedure has been
aborted. Repeat the welding procedure
with the cooled Geberit electrofusion
sleeve coupling or the cooled Geberit
electrofusion tape for anchor point.
2
3
plus another LED
Rectification
4 Switch off any non-essential
consumers.
4 Disconnect the mains plug
and contact the power
supplier.
9007201520403851-1 © 05-2017
967.778.00.0 (01)
goes