Safety-Related Information; Conventions In This Document; Meaning Of The Warning Notices; Description - Dräger X-plore 5500 Gebrauchsanweisung

1

Safety-related information

– Before using this product, carefully read these instructions for use and those
of the associated products.
– Strictly follow the instructions for use. The user must fully understand and
strictly observe the instructions. Use the product only for the purposes
specified in the intended use section of this document.
– Do not dispose of the instructions for use. Ensure that they are stored and
used appropriately by the product user.
– Only trained and competent users are permitted to use this product.
– Do not use a faulty or incomplete product. Do not modify the product.
– Notify Dräger in the event of any component fault or failure.
– Comply with all local and national rules and regulations associated with this
product.
– Only trained and competent personnel are permitted to inspect, repair and
service the product. Dräger recommend a Dräger service contract for all
maintenance activities and that all repairs are carried out by Dräger.
– Use only genuine Dräger spare parts and accessories. Otherwise, the
proper functioning of the product may be impaired.
2

Conventions in this document

2.1

Meaning of the warning notices

The following warning notices are used in this document to alert the user to
potential hazards. The meanings of the warning notices are defined as follows:
Warning sign Signal word
WARNING
CAUTION
Instructions for use |
Dräger X-plore 5500
Classification of the warning notice
Indicates a potentially hazardous situa-
tion. If not avoided, it could result in
death or serious injury.
Indicates a potentially hazardous situa-
tion. If not avoided, it could result in
physical injury. It may also be used to
alert against unsafe practices.
Warning sign Signal word
NOTICE
3

Description

3.1

Product overview (see fold-out page, Figure A)

1
Filter connector
2 Control valve
3
Inner mask
4 Visor
5
Visor frame
6
Harness
3.2

Feature description

They may only be used with certified respiratory filters from the X-plore series.
This includes e.g. uncapsulated particle filters, particle filters, gas filters or
combination filters.
The full face masks can be used at temperatures from -30 °C to +60 °C.
Mask spectacles can be inserted for users who wear spectacles.
A welding protective visor can be optionally attached for full face masks.
Among other factors, the service life depends on the type and concentration of
contaminants and on the type of respiratory filter.
3.3

Intended use

The facepieces protect the face and eyes from aggressive media.
Safety-related information
Classification of the warning notice
Indicates a potentially hazardous situa-
tion. If not avoided, it could result in
damage to the product or environment.
7 Face seal
8 Mask body
9 Clamping ring
10 Protective cap
11 Upper head-harness connector
| en
11