Schuller L3 Bedienungsanleitung Seite 28

EN |
Operation
Setting PRIMUS pull-out system
Figure set III (see page 153 f.) shows the PRIMUS
pull-out system. You can ask your dealer for the
model of your pull-out system simply by indicating
the manufacturer identification number
(see page 21).
1. Disassembly
2. Installation: Set the drawer onto the pull-out rails. Open
and close the drawer 2 times.
3. Vertical adjustment
4. Lateral adjustment
5. Tilt adjustment
6. Flat drawer: Vertical / lateral adjustment
7. Setting the gap in the case of the TIP-ON pull-out
system
Base cover installation / removal
Defective installation units can be replaced without any
problem. For this purpose, you can remove the base cover
and attach it again.
Several parts of the base cover can be glued or
screwed on. Remove the base cover carefully.
Base cover removal:
The base cover is fixed to the base slider with fastening
clips. For disassembly of the base cover, push the fas-
tening clips aside. Remove the base cover by pulling it
forwards.
28
Base cover installation:
Figure set IV (see page 155) shows the installation
of the base cover.
1. Place the side base covers in front of the lateral base
feet.
2. Place the front base covers in front of the lateral base
feet.
3. Push the fastening clips to the side in the designated
notch on the base slider until they snap in.
The base cover is fixed in place.
9
Toppling prevention
Risk of injury due to falling or toppling furniture!
Unsecured furniture can result in severe or lethal injuries.
Never remove safety installations, such as toppling
`
prevention devices of the manufacturer.
In case of a missing toppling prevention device, do not
`
use the furniture and contact your dealer.
Toppling prevention devices are required if the following
four conditions simultaneously apply.
1. Cabinets with push-ins/pull-outs
2. Body height up to 91 cm
3. Body depths 46/56/66 cm
4. Straight kitchen units, individual cabinets, kitchen
islands or tall cabinets
DANGER