Operation - Schuller L3 Bedienungsanleitung

ATTENTION
Property damage due to improper handling during
installation
Improper installation or use of non-original parts may
cause damage.
Furniture may only be installed, repaired and removed
`
by a competent person.
Replacement or repair of luminaires must only be
`
carried out by a qualified specialist.
Use only original parts.
`
Do not carry out any unauthorised conversions or make
`
any unauthorised design changes.
I nstallation is described in separately available
installation instructions and assembly instructions.

Operation

Danger due to electric currents
There is a risk of injury from electric shock if the housing
of an installed electrical device is opened or if it is han-
dled improperly.
Work on live parts must only be performed by a
`
qualified expert.
The following settings must not be carried out by the
`
end customer.
DANGER
Setting the door of the body
Figure set I (see page 150) shows the settings of
the body doors.
1. Removal / installation
2. Vertical adjustment
3. Lateral adjustment
4. Tilt adjustment
5. Damper integrated
6. Damper has been set on
Setting OPTIMUS pull-out system
Figure set II (see page 151 f.) shows the settings
for the OPTIMUS pull-out system. You can ask your
dealer for the model of your pull-out system simply
by indicating the manufacturer identification number
(see page 21).
1. Disassembly
2. Installation
3. Vertical adjustment
4. Lateral adjustment
5. Tilt adjustment
6. Creation of a gap in the pull-out system using "TIP-ON".
– "TIP-ON" is a mechanical opening support. Flap open
doors or open pull-out system simply by tapping.
Slightly pressing the front shut is enough for closing.
| EN
Operation
27