Installing Cables And Connectors; Ferrites - Mettler Toledo IND570 Installationshandbuch

5. The hardware to mount the terminal to the vertical surface is not included with the terminal—it
2.4.

Installing Cables and Connectors

Information for installing cables and connectors for the IND570 terminal is provided in this section,
including: ferrites, harsh enclosure cable glands, main board wiring connections and wiring
connections for options.
2.4.1.

Ferrites

In order to meet certain electrical noise emission limits and to protect the IND570 from external
influences, it is necessary to install a ferrite core on each cable connected to the terminal. There are
two ferrite cores included with the basic terminal and additional ferrites are supplied with each of
the options.
To install ferrites, simply route the cable through the center of the core and then take one wrap
around the outside of the core and route the cable through again. Either the complete cable or the
individual wires can be wrapped through the ferrite. This should be done as close to the enclosure
as possible. See Figure 2-15.
2-10 METTLER TOLEDO IND570 Weighing Terminal Installation Manual
Figure 2-14: Wall Bracket Mounting Hole Pattern
must be supplied locally. Ensure that the mounting hardware is capable of supporting the
weight of the terminal, which is approximately 3.5 kg (8 lb). Using the locally supplied
hardware, mount the terminal to the vertical surface.
30205319 | 02 | 04/2015