Candy CCG1S 518FW Bedienungsanleitung Seite 6

BCD-301
Location
When selecting a position for your Fridge/Freezer you should make sure the floor is flat and firm, and the room is well
ventilated. Avoid locating your Fridge/Freezer near a heat source, eg, cooker, boiler or radiator. Also avoid direct sunlight
in out-buildings or sun lounges. If you are placing your Fridge/Freezer in an out-building such as a garage or annex
ensure that the Fridge/Freezer is placed above the damp course, otherwise condensation will occur on the Fridge/Freezer
cabinet. When working, the refrigerator gives off heat to surroundings. Therefore, at least 30mm of free space should be
spared at the top side, more than 100mm on both sides, and above 50mm at the back side of the refrigerator.
Leveling the Freezer
If the Freezer is not level, the door and magnetic seal alignment will be affected and may cause you Freezer to work
incorrectly. Once the Freezer is placed in its final location, adjust the leveling feet at the front by turning them.
Cleaning before use
Wipe the inside of the Freezer with a weak solution of bicarbonate of soda. Then rinse with warm water using a damp
sponge or cloth. Wash the baskets and shelves in warm soapy water and dry completely before replacing in the Freezer.
The external parts of the Freezer can be cleaned with wax polish.
Before plugging in YOUMUST
Check that you have a socket which is compatible with the plug supplied with the Freezer. Before switching on!
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE FREEZER.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30 minutes before switching back on
to allow the coolant fluid to settle.
Before filling your Freezer
Before storing foods in your Freezer, turn the Freezer on and wait for 24 hours, to make sure it is working properly and to
allow the Freezer to fail to the correct temperature.
Switching on your Fridge/Freezer
1 Before connecting the Fridge/Freezer to the mains supply position. The thermostat control dial is located inside the
Fridge compartment.
2 Turn the thermostat knob to the"3"position and turn on electricity. The compressor and the light inside the refrigerator
will begin to work.
3 Wait 24 hours before placing food into the Fridge/Freezer, the temperature inside your Fridge/Freezer will then be cool
enough to chill and freeze foods sufficiently.
Adjusting the temperature
Temperature seting
The temperature of the appliance can be adjusted by turning the
thermostat dial.
The thermostat can be set between 1 and 7.
• 1 is the warmest setting.
• 7 is the coldest setting.
No Description
1 Cooling room shelves
2 Vegetable and fruit crisper cover
3 Vegetable and fruit crisper
4 Freezing drawers
5 Freezing drawer
6 Door balcony
7 Door balcony
4