Setting Up; Assembly/Disassembly; Choosing/Changing The Nozzle; Adding Spray Material - Parkside PFS 450 A1 Originalbetriebsanleitung

Setting up

Assembly/disassembly

♦ Move the ▸ mark on the spray unit
mark on the motor unit . Now, turn the spray
unit until the ▸ mark on the spray unit
locks into the mark on the motor unit
♦ Unlock the lock . Turn the ▸ mark on the
5a
spray unit to the
unit to separate the two units.

Choosing/changing the nozzle

Nozzle
1.5 mm nozzle
1.8 mm nozzle
2.2 mm nozzle
2.6 mm nozzle
♦ Undo the union nut
it from the spray unit
♦ Fit the desired nozzle
head .
♦ Screw the union nut
unit .

Adding spray material

♦ Unscrew the paint cup
unit .
♦ To work on a horizontal object, place the riser
pipe in front, facing the nozzle head
To work overhead, place the riser pipe
back, facing the motor unit
♦ Fill the paint cup
and screw it firmly onto the spray unit
■ 6 │ GB │ IE
to the
mark on the motor
Use
Low viscosity
Water-based paints
High viscosity
Oil-based paints
completely and remove
.
onto the nozzle
back onto the spray
from the spray
.
with the spray material
.
Switching the appliance on/off
Working methods
♦ Hold the spray gun at a constant distance from
the object. The ideal spraying distance is
approx. 15 cm.
♦ Work out the best settings by carrying out a test.
♦ Do not switch the appliance on/off over the
spray surface. Rather, start/end the spraying
process approx. 10 cm from the spray surface.
Switching on
♦ Insert the plug into a mains power socket.
♦ To switch the appliance on, pull the trigger
and keep it pulled.
Switching off
♦ To stop spraying, simply release the trigger
♦ When you are finished working, disconnect the
plug from the mains power supply.
Selecting a spray profile
Setting the spray volume
♦ Turn the spray volume adjusting wheel
the desired position:
(–) = minimum spray volume
(+) = maximum spray volume
NOTE
► We recommend starting at the minimum
setting.

Selecting a jet type

.
♦ Undo the union nut
in the
♦ Turn the protruding parts of the nozzle head
so that they point to the desired symbol on the
spray unit
The appliance has the following settings:
▯ round jet
vertical flat jet
horizontal flat jet
♦ Re-tighten the union nut
.
.
.
PFS 450 A1
.
to