Truma MonoControl CS T Gebrauchsanleitung Seite 29

MonoControl CS_T
2.1.4 Safe operation
The gas pressure regulator must not be installed any lower than the
cylinder valve to prevent gas in the liquid phase from penetrating
low-pressure parts, damaging sensitive parts and causing dangerous
gas leaks�
The gas pressure regulator contains a pressure relief valve (PRV),
which is used to relieve temporary overpressure in the gas system�
This means that gas escapes in a controlled manner�
To prevent dangerous gas from accumulating, the gas pressure

regulator must be installed in a well-ventilated space� Ventila-
tion must be guaranteed at all times� Do not close ventilation
openings�
Close the gas cylinder if the vehicle is parked in a garage�

Close the gas cylinder during transport on ferries, etc�

Chemical residues that may be contained in inferior liquid gas may
damage the product, shorten its lifespan and even lead to leaks�
A gas filter must be installed upstream of the gas pressure regulator

inlet to provide reliable protection against dirt or oil contamination�
Gas pressure regulators, automatic switchover equipment and high-
and low-pressure hoses must be replaced no later than 10 years after
the date of their manufacture in order to guarantee fault-free func-
tioning of the gas system under normal operating conditions� Earlier
replacement may be required if this is prescribed by national regu-
lations� Truma accepts no responsibility for malfunctions, damage,
injury or accidents resulting from operating gas pressure regulators,
automatic switchover equipment and high- and low-pressure hoses
that are more than 10 years old�
Replace gas pressure regulators and high- or low-pressure hoses

in good time according to applicable regulations� The user is
responsible for this�
Observe national regulations�

50020-00976 ∙ 00 ∙ 08/2022
Safety
EN 29