Maintenance And Cleaning; Kompernass Handels Gmbh Warranty; Warranty Conditions - Parkside PAAS 12 A2 Originalbetriebsanleitung

A2) Plunge cutting (see fig. E)
CAUTION! RISK OF KICKBACK!
► Plunge cuts may only be made in soft materials
(wood or similar).
1. Place the reciprocating saw with the lower edge
of the base plate
the appliance on.
2. Tilt the reciprocating saw forwards and plunge
the saw blade into the workpiece.
3. Position the reciprocating saw vertically and
continue sawing along the cutting line.
B) Working with the grip bracket (see fig. F)
♦ Push down lightly and move the saw
downwards.

Maintenance and cleaning

WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
■ Always remove the saw blade
carrying out any work on the power tool.
■ Keep the appliance and ventilation slits clean at
all times. If the ventilation slits are blocked, there
is a risk of overheating and/or the appliance
being damaged.
■ Always clean the appliance after completion
of work.
■ Do not allow any liquids to get into the appli-
ance. Use a cloth to clean the housing. Never
use petrol, solvents or cleansers which can
damage plastic.
■ Clean the saw blade mount, if necessary with a
brush or by blowing it out with compressed air.
■ If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The optimum storage
climate is cool and dry.
PAAS 12 A2
on the workpiece. Switch
before
Kompernass Handels GmbH
warranty
Dear Customer,
This appliance has a 3-year warranty valid from
the date of purchase. If this product has any faults,
you, the buyer, have certain statutory rights. Your
statutory rights are not restricted in any way by the
warranty described below.

Warranty conditions

The warranty period starts on the date of purchase.
Please keep your receipt in a safe place. This will
be required as proof of purchase.
If any material or manufacturing fault occurs within
three years of the date of purchase of the product,
we will either repair or replace the product for you
or refund the purchase price (at our discretion).
This warranty service requires that you present the
defective appliance and the proof of purchase (re-
ceipt) within the three-year warranty period, along
with a brief written description of the fault and of
when it occurred.
If the defect is covered by the warranty, your
product will either be repaired or replaced by us.
The repair or replacement of a product does not
signify the beginning of a new warranty period.
X 12 V and X 20 V Team Series battery packs
come with a 3-year warranty valid from the date
of purchase.
Warranty period and statutory claims
for defects
The warranty period is not prolonged by repairs
effected under the warranty. This also applies to
replaced and repaired components. Any damage
and defects present at the time of purchase must
be reported immediately after unpacking. Repairs
carried out after expiry of the warranty period shall
be subject to a fee.
GB │ IE │ 9 ■