Fcc Regulations; Grid Connection - Fronius Selectiva 4.0 UL B1 Bedienungsanleitung

The device must be handled correctly in order for it to work. Never pull on the
cable when handling the device.

FCC regulations

This device conforms to the limit values for a Class B digital device, pursuant to
Part 15 of the FCC regulations. These limit values are designed to provide reas-
onable protection against harmful interference in a residential installation. This
device generates and uses high frequency energy and, if not used in accordance
with the instructions, may interfere with radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this device does cause harmful interference to radio or television reception,
which can be determined by turning the device off and on again, the user is en-
couraged to try to correct the interference using one or more of the following
measures:
-
-
-
-

Grid connection

Danger from electrical current.
This may result in serious injuries or death.
▶
▶
Danger from incorrect operation and work that is not carried out properly.
This can result in severe personal injury and damage to property.
▶
▶
▶
Danger due to faulty or insufficient grid power supply.
This can result in severe personal injury and damage to property.
▶
16
FCC
Reorient or relocate the receiving antenna.
Increase the distance between the device and the receiver.
Connect the device to a different circuit than the receiver.
Consult the distributor or an experienced radio/TV technician for help.
WARNING!
Before starting work, switch off all devices and components involved, and
disconnect them from the grid.
Secure all devices and components involved so they cannot be switched back
on.
WARNING!
All the work and functions described in this document must only be carried
out by trained and qualified personnel.
Read and understand this document.
Read and understand all the Operating Instructions for the system compon-
ents, especially the safety rules.
WARNING!
The requirements for the grid power supply according to the "Technical data"
chapter must be fulfilled.