Controlling The Extraction Tower; Switch On And Off And Run-Out Function; Increase And Decrease The Power Level; Auto-Stop - Novy 1821 Panorama Bedienungsanleitung

4.4 Controlling the extraction tower

4.4.1 Switch on and off and run-out function


WARNING: When the extraction is activated, the
extraction tower automatically rises to the desired
height at the rear of the induction hob. Therefore,
ensure nothing can hinder its movement.
Extraction tower:
Switch on 10 cm
Briefly press
Switch on 30 cm
Press and hold for 2 seconds
Switch AUTO on 20 cm
Press
AUTO function: Preset function where the extraction tower
immediately comes into position at the most common cooking
height of 20 cm. The extraction mode 6 (3rd led) is automatically
set.
Run-out function: This function starts at the end of cooking.
For a fixed time, the remaining cooking vapours will be extracted
from the kitchen by the extraction tower at low extraction mode
and at a height of 10 cm. When recirculation is selected, the
Monoblock filters are also dried.
The run-out time is set to 30 minutes by default in the recirculation
mode and 10 minutes in exhaust mode. It is recommended that
this function be allowed to carry out its function completely. At
the end of the run-out time, the motor and the extraction tower
will automatically switch off and the tower will close.

4.4.2 Increase and decrease the power level

The extraction tower can be set to 8 power levels, with 3 intense
levels (6, 7 and 8).
Activate the intense levels when cooking food with a strong
smell or vapour. On higher flow rates, the extraction tower works
for a fixed period of time: 1 hour on position 6, and 6 minutes on
position 7 and 8 if the device is set to exhaust mode. After this
time, the extraction tower switches back to position 5.
Adjusting the power level:
Increase the power
+
Press
Decrease the power
‐
Press

4.4.3 Auto-stop

In order to ensure the extraction does not keep running, the
motor switches off and the extraction tower closes automatically
after 3 hours (if the controller has not been changed during
these 3 hours).

4.5 Cleaning indications

4.5.1 Cleaning indication for grease filter


Display
Indication: White LED next to
1st LED
After 20 cooking hours, the white LED next to the
lights up
will light up.
1st LED

Follow the cleaning instructions as described in the
lights up
chapter, Cleaning.
3rd LED
After having cleaned and replaced the grease filters, reset the
lights up
cleaning indication.
Reset: press the
4.5.2 Cleaning indication for Monoblock recirculation
filter (only with recirculation)

Indication: White LED next to
After 200 cooking hours, the white LED adjacent to the
symbol will light up (this indicates that the Monoblock
recirculation filter must be regenerated.

Follow the cleaning instructions as described in the
chapter, Cleaning.
After the regeneration and after having replaced the Monoblock
recirculation filter, reset the cleaning indication.
Reset: press the
Brighter
LED(s)
LED(s)
dim
– 65 –
lights
control key for 3 seconds.
lights
control key for 3 seconds.
symbol