Programming The Remote Control - Novy InTouch Bedienungsanleitung

EN
Intouch
The InTouch features on the induction hob work with the extraction hood. These are
the symbols on the induction hob with their corresponding functions:
Switch extraction hood on
Switch extraction hood off  Touch once with run-out mode
Increase speed
Reduce speed
Lights on/off
 Lights dimming: Touch

Programming the remote control

The remote control is preprogrammed and works directly with the hood.
If the set frequency disrupts other transmitters, another code can be selected using
the remote control. There are 10 different codes.
Press and on the remote control at the same time.
• The light on the remote will flash the same amount of times as the pre-set code.
1
Press for 3 seconds
until the light flashes on the remote control.
The light on the remote will flash the same amount of times as the pre-set
code.
If a different code is desired repeat this step again.
2
Press
same time on the hood until
the 2nd green LED flashes.
Controller
 Touch twice without run-out mode
until the desired brightness is achieved.
Determining the used code:
Changing the frequency code:
and
and at the
– 9 –
on the remote control at the same time
3
Now press the
the remote control within
3 seconds to confirm the
settings.
key on