Setting The Day And Time - Heatscope TUNE Installations- Und Gebrachsanleitung

setting tHe day and time

EN
MO TU
1. Hold your finger on the touch point until the seven triangles start to flash on the left side.
2. Touch the relevant triangle to select the current day of the week and then press the
touch point to confirm. If you have selected the wrong day, simply touch the correct day
again. If you have accidentally already pressed the touch point to confirm, start again at
Step 1.
3. Once you have confirmed the day, only the displays needed for the next step will be illu-
minated – i.e. for setting the time. Use the selection button to set the first number of the
four-digit time display and then press the touch point to confirm. The HEATSCOPE
will take you through each of the four digits for the time display. Confirm each one with
the touch point. Once you have confirmed the last number of the four-digit time display,
the HEATSCOPE
4. C0 – normal operation (standby, only the red spot is visible)
C1 – time is permanently displayed
C2 – proximity sensor is switched off (standby, only the red spot is visible)
• If you stop programming the time and do not confirm all four digits for the time with the
touch point, the HEATSCOPE
after a few seconds and will retain the most recently confirmed value.
• In the event of a power failure, the time and day settings will be stored for several days.
20
Time
1 2 3 4
88.88
WE TH FR SA
DAYS OF THE WEEK
TUNE will automatically exit the menu for setting the day and time.
®
®
TOUCH POINT
SU
SELECTION BUTTONS
Program selection
TUNE will automatically exit the time programming menu
5
88
Time setting
Duration
TUNE
®