Heatscope TUNE Installations- Und Gebrachsanleitung Seite 25

starting tHe on-demand timer in tWo stePs
Starting the on-demand timer
1. Press the touch point multiple times to adjust the time in 20-minute intervals
(20, 40, 60, 80 and 90 minutes).
2. S Mode
Once you have set the duration, you have the option to set the temperature of the
HEATSCOPE TUNE to a lower level for the selected duration by pressing the S mode
®
button. Please note that in this mode, it takes slightly longer to warm and dry your towels.
• A few seconds after you have selected the time, the display changes to 'on' in the
operating mode. The HEATSCOPE
mode, the HEATSCOPE
with the 'on' display, the S mode is not activated.
• The automatic switch-off is always activated and the HEATSCOPE
automatically once the selected running time has ended.
• Press the touch point again to display the remaining time.
• If you wish to switch the HEATSCOPE
several times until '00' appears on the display. The HEATSCOPE
off.
• The on-demand timer can be activated at any time and independently of the program-
med weekly timer. Thanks to the extremely fast response time of the HEATSCOPE
you can enjoy the comfort of the HEATSCOPE
programmed times.
On-demand timer,
duration, status
5
88
TOUCH POINT
Entering duration for
on-demand timer
TUNE is now switched on. If you have activated S
®
TUNE will display this. If the 'S' does not light up simultaneously
®
TUNE off before the end, press the touch point
®
A M B I E N T H E A T I N G S O L U T I O N S
S MODE
Temperature
limiter
®
®
TUNE at short notice, even outside of the
®
TUNE switches off
TUNE is now switched
TUNE,
®
EN
25