Heatscope TUNE Installations- Und Gebrachsanleitung Seite 32

installation instruCtions For mounting on Walls or Ceilings
• Check the contents of the packaging.
• Select the installation location
(please read the installation and mounting guidelines carefully first).
• Use a spirit level or a metre stick to line up the cardboard drilling template
on a level and clean surface.
TIP: Stick the cardboard drilling template to the wall with masking tape.
EN
• The supplied cardboard drilling template is used for installing the HEATSCOPE
• For installation on concrete, solid blocks, brick, limestone, sandstone or autoclaved
aerated concrete, use a drill and the relevant 8 mm drill bit to drill a hole approx. 50 mm
deep. Blow any residue out of the holes and insert the four (or six) supplied dowels
into the holes.
• For safe attachment, above all on plasterboard walls and ceilings, it must be ensured
that special connection technology is used and installed correctly in accordance with
the load data. If necessary, consult an expert to ensure a professional solution.
• Please ensure that you have a level installation surface.
TIP: You can use a smaller drill bit to pre-drill the hole and make the drilling position
more accurate.
• For installation on wood, use a drill and the relevant 4 mm drill bit to drill a hole
approx. 50 mm deep.
• Put the Neoprene seals on the hexagon head wood screws 5 x 50 mm and screw
these into the wall or ceiling until approx. 5 mm remains.
• Carefully mount the heating element.
• To secure the device during ceiling installation, now use pliers to rotate one pair
of installation brackets by 180°.
• Use the 8 mm open-end or ratchet wrench to tighten the hexagon head screws.
TIP: Be sure to route the power cable according to the location of the socket
or power connection.
32
devices.
®