Setting The Brightness - Heatscope TUNE Installations- Und Gebrachsanleitung

setting tHe BrigHtness

1
88.88
PROGRAMMING BUTTON
1. Hold your finger on the programming button until the selection buttons start to flash
and SET 01 appears on the display (approx. 10 seconds). Take your finger off the pro-
gramming button.
2. Use the up and down selection buttons to change the brightness until it suits your lighting
and the display is easy to read. Use the programming button to confirm the setting and
save the brightness.
• If you stop adjusting the brightness and/or do not confirm the setting, the HEATSCOPE
TUNE will automatically leave the menu after a few seconds and will retain the most
recently confirmed value.
• In the event of a power failure, the chosen brightness setting will be stored
for several days.
general sWitCH-on and sWitCH-oFF
The ON/OFF switch is on the side of the HEATSCOPE
device off. We recommend switching the device off if you go on holiday or are away for a long
period.
2 3 4
SELECTION BUTTONS
Program selection
A M B I E N T H E A T I N G S O L U T I O N S
Time setting
Duration
TUNE. Press the switch to turn the
®
EN
®
21