Temperature Limiter; Deactivating The Timer - Heatscope TUNE Installations- Und Gebrachsanleitung

4. When you have confirmed the final digit for the start time with the programming button,
the on-demand timer display on the right will light up and you can use the selection
buttons or the touch point to set the duration in 10-minute intervals. Touch the program-
ming button to confirm the selected duration. The first start time and the subsequent
duration are now programmed for the selected days.
EN
PROGRAMMING BUTTON
5. The S now flashes on the right side. The S is used to select the operating mode. If you
want the HEATSCOPE
and it will light up constantly. The S mode is activated. The HEATSCOPE
limited to a lower temperature. Please note that in this mode, it takes slightly longer to
warm and dry your towels. If you want the HEATSCOPE
do not press the S. Use the programming button to confirm your selection and save the
operating mode for the selected time.
PROGRAMMING BUTTON

deaCtivating tHe timer

Switching off the device at the ON/OFF switch deactivates the weekly timer. The programmed
days, idle times and running times will remain saved.
• Press the programming button once and select the memory space. Then press all
days of the week that are not flashing, until all seven days are flashing, and press the
programming button to confirm your selection. The weekly timer is now deactivated for
the selected memory space. The switch-on times and running times are retained and are
now deactivated.
• Repeat this step for all of the eight memory spaces that you have programmed.
• In the event of a power failure, the programmed times will be stored for several days.
24
TOUCH POINT
Entering duration for
on-demand timer
TUNE to run at a lower temperature in the set time, press the S
®
S MODE
Temperature
limiter
5
88
TUNE to run in normal mode,
®
TUNE is now
®