Initial Use - Heatscope TUNE Installations- Und Gebrachsanleitung

initial use

Connect the power cable to a socket and press the ON/OFF switch (on the side of the
HEATSCOPE TUNE). The short initialisation phase lasts for approx. 1 minute. After that, only
®
the touch point at the top right is visible and the HEATSCOPE
overvieW oF disPlays and Controls on tHe
HeatsCoPe tune Control Panel
®
Time, start time,
program selection
1 2
88.88
MO TU WE
DAYS OF THE WEEK
Selection for weekly timer
PROGRAMMING BUTTON
• If you move your hand towards the touch point without touching the HEATSCOPE
the programming button and the time will automatically appear on the left.
• If you don't change any settings, the display will switch off again after a few seconds.
Only the touch point on the right will remain illuminated.
3 4
TH FR SA SU
A M B I E N T H E A T I N G S O L U T I O N S
TUNE is ready to use.
®
On-demand timer,
duration, status
5
88
TOUCH POINT
Entering duration for
on-demand timer
SELECTION BUTTONS
Time setting
Duration
Program selection
S MODE
Temperature
limiter
TUNE,
®
19
EN