BestWater Jungbrunnen 22-00 ULTIMATE Gebrauchsanleitung Seite 61

Remove the old 20 µm pre-filter car-
tridge and insert a new 20 µm pre-filter
cartridge. Turn the cartridge finger-tight
into the right filter head.
Semi-annual filter change of the 20 µm pre-filter cartridge
Once the 20 µm pre-filter has been
replaced you can reattach the front
hatch to the
Finally, you must disinfect the unit.
Close the front hatch by using the star screwdriver
®
Close the stopcock on the stored pres-
sure tank. Remove the hose from the
stopcock of the stored pressure tank.
Close the tap on the pressure tank and remove the hose
Maintaining the BestWater System
BestWater system.
-
Star screwdriver
Set the disinfection module onto the
stopcock of the stored pressure tank and
connect it to the BestWater system so
that the purified water can flow through
the disinfection module into the tank.
Install the desinfection modul to the stored pressure tank
You can now turn on the flow of water to
the appliance.
Open the water supply at the corner valve
Wait about 5 minutes, until the pre-filters
have filled with water and been rinsed.
Open the stopcock on the reservoir tank.
The system is now producing purified
water that flows through the disinfection
module and dissolves the hydrogen per-
oxide (H O ) within the disinfection mo-
2 2
dule.
When draining later, the disinfectant will
disinfect all hoses that the purified water
passes through.
Open the tap on the stored pressure tank if the disinfection-
module is installed
EN
61