BestWater Jungbrunnen 22-00 ULTIMATE Gebrauchsanleitung Seite 55

The water stopper
Follow these steps to connect the water
stopper:
1. Open the rear battery case of the
water stopper. Insert one AA battery
into the water stopper and close the
rear battery case again. Change this
battery after each filter change, or
once per year.
2. Screw the 1/4" connector IT with
3/4" IT onto the 3/4" Y distributor.
3. Screw the water stopper onto the
3/4" Y-distributor. A washing machine
or dishwasher can also be connected
to the Y-distributor. The water stopper
is only applied finger-tight.
4. Make sure that the contaminant
filter is installed in the water stopper.
5. Mount the water stopper with the
Y distributor onto the corner valve of
your cold water connection.
6. Please place the 1st sensor directly
next to the unit and the 2nd sensor of
the Water-Stopper at the lowest point
in your built-in cupboard.
Water-Stopper installed on the corner valve
Setting Up and Connecting
The hose connections
Use these images to install the hose con-
nections onto the Jungbrunnen 22-00
ULTIMATE, and follow these steps:
Insert the plug-in sockets into the bulk-
head connector on the side of the Jung-
brunnen 22-00 ULTIMATE.
Plug-in sockets installing
®
Insert the 1/4" plastic hoses into the
plug-in sockets of the Jungbrunnen 22-
00 ULTIMATE one after another.
Hoses installing
®
Once all plastic hoses have been
connected to the Jungbrunnen 22-00
ULTIMATE, insert the mains water hose
from the Jungbrunnen 22-00 ULTIMATE
into the 1/4" connector on the water
stopper.
Hoses installed
®
Plug-in Sockets
-
-
A
-
55
EN