BestWater Jungbrunnen 22-00 ULTIMATE Gebrauchsanleitung Seite 49

The drain
The drain of the BestWater system can
be applied to all 40 - 50 mm thick plastic
hoses with ease.
Figure out where you will set up the drain
clamp before installation.
Note that the water drain should be vi-
sible once completely installed.
Drain drilling Frontview
(with marks)
Drain clamp installation Sideview
1.
Foam rubber gasket
( 7 mm Ø hole)
Screw
Drain clamp 40 mm Ø
(1/4" Plug-in connector)
3.
Drain hose 1/4" 1.
Plug-in connector 1/4"
Nut
2.
After you have determined where the
drain clamp will be installed, drill a hole
above the air trap with a 7 mm drill bit.
Remove the residue after drilling.
Fasten the clamp to the trap. Turn the
screws equally among the drain installa-
tion kit.
No additional fittings (pressure redu-
cers, check valves, etc.) may be installed
on the hose to the drain clamp.
2.
Drain clamp installed Frontview
(with installed drain hose)
EN
49