BestWater Jungbrunnen 22-00 ULTIMATE Gebrauchsanleitung Seite 56

Setting Up and Connecting
EN
Tap water hose installing
Insert plastic hose
the stored pressure tank.
Install the hose in the shut-off valve of the reservoir
pressure tank
Drain hose B
into the drain clamp on the trap. Push
the plastic hose 30 mm into the drain
clamp connector.
Install the drain hose into the drain clamp
Insert the purified water hose
connector IT of the faucet.
Connect the permeat hose to the designer faucet
Sink
56
C into the stopcock of
is inserted from the system
D
Counter top
Permeat hose
Connect the permeat hose to the three flow faucet
Sink
Open the water line to the Jungbrunnen
22-00 ULTIMATE.
Open the water supply at the corner valve
Turn on the faucet and let the water run
for about 10 minutes. Fill up the Jung-
brunnen 22-00 ULTIMATE two times in
order to rinse out any residual disinfec-
tant.
Inspect all hose and socket connections
to make sure they are properly sealed.
After 10 minutes 10 you can open the
stopcock on the stored pressure tank.
The installation of the Jungbrunnen 22-
00 ULTIMATE is now complete. You may
now extract clean drinking water from
the faucet.
into the
Ensure that the hoses have been inser-
ted deeply enough into the connectors
and are not buckled.
Counter top
Permeat hose
Sink