Drilling Cup Inclination - Checchi & Magli WOLF Bedienungsanleitung

The cup fixed at reference point N 1 must not be removed (fig. 18.C).
Warning: to use the distributor with only 1 or 2 cups installed, N 2 phasing
spacer shafts (fig. 18.D) must be fixed to the distributor to enable the group to
operate correctly.
- 1-cup version, spacers in housings 5 and 9.
- 2-cup version, spacers in housings 4 and 10.

24.0 - DRILLING CUP INCLINATION

The clamp (fig. 19.B) allows vertical adjustment of the cups (fig. 19.D):
Fig. 19.C - cups in a vertical position; considered the standard position.
Fig. 19.D - cups inclined to the rear; considered the corrective position, advisable
when transplanting on plastic film, at a distance between plants obtained using setting
19 (wheel) and 17 (hexagonal shaft) (see chapter 19, fig. 13).
By adjusting the screws (fig. 19.A) and fixing the clamp (fig. 19.B) in the bores (fig.
19.C') the cups are set to the standard position (fig. 19.C).
By fixing the clamp (fig. 19.B) in the bores (fig. 19.D') the cups are set to the inclined
position (fig. 19.D).
C
A
1
12
11
10
9
8
7
60
B
1
2
3
4
5
6
1
D A
B
WOLF
WOLF-COMPACT
N° HOUSINGS
6 1 2 5
5 1 3 6
4 1 4 7 10
3 1 5 9
2 1 7
1 1
1
C
7 9 12
8 11
D
FIG. 18
C
D
FIG. 19