Functions Of The Operator; Transplant Unit In Work Phase; Check That An Oscillation Space Of Approximately 2 Cm Remains Between; Transplant Depth - Checchi & Magli WOLF Bedienungsanleitung

16.0 - FUNCTIONS OF THE OPERATOR

Pick up the plants from the special containers and place them correctly in the distributor
drill cups (fig. 9).
Decide, with the tractor driver, upon a working speed which allows sufficient time to
perform the above functions properly.
Make constant visual checks of the transplant quality, and in the event of anomalies,
give the STOP signal, so that you can check the causes and take the necessary
corrective action.

17.0 - TRANSPLANT UNIT IN WORK PHASE

17.1 - Use the drive wheel adjustment device (fig. 10.A) to set the transplant units
to a horizontal position in relation to the ground (fig. 10.B).

17.2 - Check that an oscillation space of approximately 2 cm remains between

the beam stop and the linkage (fig. 11).
This is essential to allow the transplant unit to adapt itself to any unevenness in the
ground.

18.0 - TRANSPLANT DEPTH

Adjust the rear wheel height register (fig. 10.C)
- TO INCREASE DEPTH turn in a clockwise direction.
- TO DECREASE DEPTH turn in an anti-clockwise direction.
After each adjustment, ensure that the hood elements (fig. 10.D) are at least 2 cm
above the ground or the plastic mulching film (fig. 10.E).
This is to avoid any mechanical breakages, malfunctions and damage to the
plastic film.
56
C
B
FIG. 9
FIG. 11
WOLF
WOLF-COMPACT
D E
A
A
B
FIG. 10
A
FIG. 12