Installation Positioning - x-sense Link XS01-WR Bedienungsanleitung

Indication • The alarm will sound
3 short quick beeps.
• The red LED will
fl ash once every
second during the
audible signal.
• After testing,
the alarm will
automatically
enter standby
mode.
NOTE: The test function accurately tests the alarm's smoke sensing circuit
without the need to test with smoke. If your smoke alarm fails to give an
audible test signal, please refer immediately to the troubleshooting guide
at the end of this manual. Never use an open ame to test this device.
• The initiating smoke alarm will
beep continuously with the red LED
fl ashing.
• Other interconnected smoke alarms
in the network will receive the
signal after 5 seconds, and they will
beep continuously with the red LED
fl ashing. Release the test/silence
button and all the smoke alarms will
stop testing.
• The testing of the units should be
completed within 3 minutes.
• After testing, the units will
automatically enter standby mode.
10

Installation Positioning

Smoke Alarms
Carbon Monoxide Alarms
NOTE: If a smoke alarm is installed in a kitchen, ensure it has an accessible
silence button, and install it as far away from the stove and sink as
possible to avoid false alarms.
Smoke & Carbon Monoxide Alarms
Fire Extinguishers
11