x-sense Link XS01-WR Bedienungsanleitung Seite 5

2. Test all wireless alarms to ensure they are interconnected before
installation.
3. A maximum of 24 wireless alarms can be interconnected on the same
network.
4. The model can only be interconnected with other X-Sense Link
interlinked alarms.
+
How to Add X-Sense Link Wireless Interlinked Alarms to the X-Sense
XS01-WR Network
The XS01-WR model has 2 versions: the old version, XS01-WR, and the
+
new version, X-Sense Link XS01-WR, which have diff erent interconnection
methods. The new version belongs to the X-Sense Link
+
a "Link " icon on the label on the back of the unit. Check whether the "Link
icon is on the label to distinguish between these 2 versions.
Old Version XS01-WR
NOTES:
1. The following instructions for wireless interconnection are only
applicable to the old version of the X-Sense XS01-WR wireless interlinked
smoke alarms, not the X-Sense Link
+ wireless
+
series and there is
+
New Version XS01-WR (X-Sense Link Series)
+
wireless interlinked alarms.
06
2. If you have purchased the old version of the XS01-WR alarms, you can
add X-Sense Link
interconnected network.
1. To ensure that an X-Sense Link
connects to an X-Sense XS01-WR network, choose one of the previously
interconnected XS01-WR smoke alarms, remove it from the mounting
bracket, and keep this alarm at least 33 ft (10 m) away from the other
alarms in the existing network.
2. Turn on one X-Sense Link
operating instructions. Quickly press its test/silence button twice; the
alarm will beep once, and the LED will fl ash red rapidly as it searches for a
network to connect to. Next, quickly press the test/silence button 4 times
+
"
on the XS01-WR alarm that was removed from the mounting bracket; it
will beep once and the LED will fl ash red rapidly, indicating it is ready to
add a new device to the network.
3. After the two units successfully pair, both units will beep once and
automatically exit the interconnection mode. At this point, the X-Sense
+
Link alarm has also joined the existing XS01-WR network. Both units will
only fl ash once per minute, indicating they are in normal standby mode.
4. If you want to connect more X-Sense Link
simply repeat step 1-2. Up to 24 alarms can be interconnected this way. To
ensure that all alarms enter the same interlinked network, make sure you
add X-Sense Link
5. Test the alarms according to the steps in the section "Alarm Test".
+
wireless interlinked alarms into the existing XS01-WR
+
wireless interlinked alarm successfully
+
wireless interlinked alarm according to its
+
wireless interlinked alarms,
+
wireless interlinked alarms one at a time.
07