Checchi & Magli BABY TRIUM Bedienungs- Und Wartungsanleitung Seite 70

3) Load the seedlings into the dispenser and keep it
loaded during the planting stage.
Do not load the seedlings into the front cups as they
are continually opening and closing.
4) The operators on the work vehicle must decide on
the tractor's speed of travel together with the tractor
driver so that a least 60 seedlings can be placed in
the dispenser per minute and correct ejector/seed-
Night-time work or poor visibility conditions
Working at night or in poor visibility conditions increases the risks arising from machine use; in these conditions,
proper lighting must be provided to ensure safe work.
Transporting the work vehicle
Danger - Warning
For work vehicle loading/unloading, use lifting
equipment with a suitable capacity for the load to be
lifted.
Use all possible caution when lifting to avoid dam-
aging the machine and causing injuries to persons
involved in operations.
Strap up the vehicle at the lifting points envisaged by
the manufacturer.
See the strap-up points and lifting procedures in the sec-
tions titled "Lifting the BABY TRIUM" on page 14 or "Lift-
ing the BABY TRIUM DT" on page 15.
UN41-0193MG
English language
INFORMATION FOR USE
ling timing is obtained.
5) Move forwards with the tractor before starting the
planting.
6) The operators on the work vehicle must check the
planting quality constantly. In the event of anoma-
lies, stop the tractor moving forwards and adopt cor-
rective measures (see "Information on adjustments"
and "Troubleshooting"- pages 18 and 33).
Anchor the work vehicle to the means of transport with
ropes and secure the wheels with wedges.
Vehicles which are narrower than the maximum width
allowed by the highway code can be loaded, coupled to
the tractor, onto suitable means of transportation using
loading ramps.
Danger - Warning
Thoroughly clean the ramps and loading platform
before boarding the vehicle.
Position the ramps on the transport means and fix
them in a stable way to the truck bed using the fas-
tening devices (pins, screws, chains, etc.).
Where the ramps meet the truck bed there is a dan-
gerous bump so move the machine very carefully
over this point.
28
6
Use and maintenance