Storage And Disposal - Husqvarna AUTOMOWER FlexiFence Bedienungsanweisung

Symptoms
Symptom
The robotic lawn mow-
er stops with the fault
message "Zone genera-
tor problem".
The robotic lawn mow-
er enters the FlexiFence
zone.

Storage and disposal

To put the product into storage
WARNING:
get access to the product.
1. Charge the battery of the product.
2. Clean the product. Refer to
3. Put the product into storage in a dry, closed and frost-free area.
1685 - 004 - 26.10.2022
Cause
The battery of the Flex-
iFence is low. The Flex-
iFence does not oper-
ate when the battery
is empty. The robotic
lawn mower can cut
in the stay-out zone if
you start the robotic
lawn mower before you
charge the FlexiFence.
The FlexiFence is auto-
matically set to off be-
cause the temperature
in the FlexiFence is a
higher than the maxi-
mum limit.
Software transfer prob-
lem.
Put the product in an area where a child cannot
To clean the product on page 11 .
Solution
Charge the battery of
the FlexiFence before
you start the robotic
lawn mower.
Put the product in an
area with protection
from the sun. Let the
temperature of the prod-
uct decrease before you
start the product.
Push the ON/OFF but-
ton for 15 seconds to
restart the product.
13