Husqvarna AUTOMOWER FlexiFence Bedienungsanweisung Seite 8

CAUTION:
Note:
Refer to the Operator's manual for the robotic lawn mower or
www.husqvarna.com for more information about installation.
Installation of the product
To prepare for the installation of the product
• Charge the battery of the product. Refer to
10 .
• Install the stay-out zone in the work area of the robotic lawn mower, but
not across a guide wire.
• Make sure that the FlexiFence and all objects in the FlexiFence area are
minimum 35 cm / 14 in. from the zone boundary wire (A). (Fig. 8)
• Make sure that the minimum distance from the zone boundary wire to the
boundary wire of the work area (B) is 60 cm / 24 in.
• Make sure that the minimum distance from the zone boundary wire to the
guide wire (C) is 60 cm / 24 in.
• If you use more then 1 FlexiFence unit, make sure that the minimum
distance between the 2 zone boundary wires is 60 cm / 24 in.
• Make sure that the slopes in the FlexiFence area are not more than 10%.
• Make sure that the length of the zone boundary wire is maximum 15 m / 50
ft.
• Do not put the zone boundary wire across the same zone boundary wire
or a different zone boundary wire installation. This can cause interference
with the product and the zone boundary wire. (Fig. 9)
• To put the FlexiFence at a distance to objects, read the section To
examine where to put the boundary wire in the Operator's manual for the
robotic lawn mower.
Note:
Use the included parts for installation. You can speak to your
Husqvarna representative to get more parts for installation.
8
Use original spare parts and installation material.
To charge the battery on page
1685 - 004 - 26.10.2022