Sirona INEOS Inbetriebnahme Seite 23

Sirona Dental Systems GmbH
Startup and Installation Instructions for the inLab PC system inEos
60 35 302 D 3446
D 3446.031.01.05.02 06.2009
7. Observe the message
Instructions, Chapter on "Calibration").
"OK"
8. Confirm the list with
Following a successful calibration, the inLab 3D software of the
connected inEos is automatically detected each time the unit is
restarted and the software download will be performed automatically
as required.
The status bar at the bottom right of the inEos program screen
indicates that the software is being transferred.
The transfer process is completed in approx. 10 sec.
The power LED lights up constantly when the download is completed.
"Calibration necessary"
(see inEos Operating
.
2 Initial startup
9