2 Initial startup
8
Startup and Installation Instructions for the inLab PC system inEos
2
Initial startup
After all connections have been made, proceed as follows:
1.
Switch the monitor on.
2.
Switch the inLab system PC on.
The PC boots up without an error message.
3.
Switch the inEos on.
The power LED starts flashing.
4.
Start the inLab 3D software.
"Settings"
5.
In the menu
automatically"
.
The software will search the inLab system PC for connected devices.
If the inEos is properly connected (see "Making connections" [ 5])
the software is downloaded to COM3. The scanner is then detected
as an inEos unit and its serial number will be displayed.
6.
If you would like to add the inEos to your device list, click
The inEos now appears in the configuration list.
Sirona Dental Systems GmbH
"Configuration"
"Devices..."
/
/
D 3446.031.01.05.02 06.2009
"Add
click
"Add Device"
.
60 35 302 D 3446