Replacing The Light Bulbs - Respekta CH 66060 BSGA Bedienungs- & Installationsanleitung

6.3

Replacing the light bulbs

WARNING: The light bulbs must be replaced by the manufacturer, by its technical
assistance service, or by persons with similar qualifications.
WARNING: Always disconnect power from the appliance before carrying out any
maintenance operations. Before handling the light bulb, make sure it is cool to the touch.
WARNING: When handling the light bulbs, hold them with a cloth or wear gloves to avoid
sweat collecting on the glass resulting in reduced lifetime of the bulb.
WARNING: When changing a light bulb, make sure the new bulb's power rating is no
higher than that of the original.
WARNING: Before changing the light bulbs, make sure the appliance is switched off and
disconnected.
WARNING: Protect yourself from risks when changing the light bulbs, e.g. by wearing
gloves.
- Open the upper glass panel and remove the grease filter; insert one hand into the recess and gently
push the LED light outwards.
- Use the other hand to extract the LED light and then detach the electrical connector.
- To install a new LED light follow the reverse procedure.
The ILCOS D code for this bulb is: DSR-1.5/65-S-64
LED modules - round bulb
Maximum power: 2×1.5 W
Voltage range: 12V DC
Dimensions (A): 64 mm
A A
en-36
Fig. 6.2