Respekta CH 66060 BSGA Bedienungs- & Installationsanleitung Seite 57

A A B B C C D D E E F F
Fig. 4.2
After connecting the hood to the electricity network, all the button indicator lights will switch on for 2
seconds to show the condition, and the hood will assume standby status.
Press the on/off button (F); the button indicator light will switch on and the hood will start operating at
low speed. Speed level 1 indicator light (A) will switch on. Press the on/off button again and both the
on/off button indicator light and the low speed button indicator light will switch off. The hood will enter
standby mode.
The speed buttons and the light button can operate separately and are not controlled by the on/off
button. When you press a function button, the hood will operate in the related mode. Press the on/off
button to interrupt any set function.
Press light button (D) once; the lights will switch on and the indicator lights will come on in the light
button and on/off button. Press the button again to switch off the lights.
Press speed level 1 button (A), the indicator light switches on and the motor runs at low speed. If you
press the button again, the motor will stop and the indicator light will switch off.
Press speed level 2 button (B), the indicator light will switch on and the motor will run at medium speed.
If you press the button again, the motor will stop and the indicator light will switch off.
Press speed level 3 button (C), the indicator light will switch on the motor will run at high speed. If you
press the button again, the motor will stop and the indicator light will switch off.
Low speed (A), medium speed (B), and high speed (C) cannot function simultaneously. When the hood
is set to high speed, when the low speed button is pressed the motor immediately switches to low speed;
when the medium speed button is pressed the motor immediately switches to medium speed, and so
forth.
The delay button (E) can enable the delay function only when the hood speed button and lighting button
are on. Press delay button (E) once to enable the delay function. The button indicator light will come on.
The hood will run for 5 minutes and then switch off automatically. Also the lighting and all indicator lights
will switch off. The hood will enter standby mode.
en-18