Safety Information - Hach NT3100sc Benutzerhandbuch

Specification
Measuring interval
Units
T100 response time
Signal average
Power consumption
Cable length
Environmental rating
Sensor pressure limit
Ambient temperature
Sample temperature
Dimensions (Ø x L)
Weight
Altitude
Pollution degree
Overvoltage category
Environmental conditions Outdoor use
Sensor materials
Process connection
Certifications
Warranty
Section 2 General information
In no event will the manufacturer be liable for damages resulting from any improper use of product or
failure to comply with the instructions in the manual. The manufacturer reserves the right to make
changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.

2.1 Safety information

The manufacturer is not responsible for any damages due to misapplication or misuse of this product
including, without limitation, direct, incidental and consequential damages, and disclaims such
damages to the full extent permitted under applicable law. The user is soley responsible to identify
4 English
Details
15, 30 seconds, 1, 5, 10, 30 minutes
mg/L, ppm
1 minute
1 to 12 measurements
9 W
10 m (33 ft)
Extension cables are available: 5, 10, 15, 20, 30 and 50 m. The maximum cable
length is 60 m (190 ft).
IP 68
0.5 bar (7.3 psi)
2 °C to 40 °C (36 °F to 100 °F), 95% relative humidity, non-condensing
2 °C to 40 °C (36 °F to 100 °F), 95% relative humidity, non-condensing
70 × 470 mm (3 × 18.5 inches) approximately
4.8 kg (10.6 lb) with 10 m cable
2000 m (6562 ft) maximum
2
III
Enclosure: Stainless steel
Enclosure seals: Silicone
Wiper shaft, arm (5 mm) and wiper blade carrier (1 mm and 2 mm): Stainless steel
Wiper blade: Silicone
Measuring window: Quartz glass
Sensor cable: Polyurethane (PUR)
Cable gland: Stainless steel
Seal cable gland: Silicone HT
Immersion directly in media
Bypass with flow through unit
Sedimenter
CE, CMIM and UKCA approved, FCC, ISED
1 year (EU: 2 years)