Ferm CTM1017 Bersetzung Der Original Bedienungsanleitung Seite 8

Grinding stones
Fig. 3
When using a grinding stone the first time, use the
dressing stone to balance it. The dressing stone
can also be used for cleaning the surface or to
give the grinding stone a special shape.
Material
Stone, shell
Steel
Aluminium, brass
Plastic
Felt wheels
Fig. 4
The felt wheels should be screwed on the
mandrel.
Material
Steel
Aluminium, brass
Plastic
Sanding bands and disc
Fig. 5
Material
Wood
Steel
Aluminium, brass
Plastic
High speed cutter, Diamond wheel point and
Drill
Fig. 6
Material
Stone, shell
Steel
Aluminium, brass
Plastic
5. MAINTENANCE
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
This machine has been designed to operate over a
long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon
proper machine care and regular cleaning.
8
Cleaning
Keep the ventilation slots of the machine clean to
prevent overheating of the engine. Regularly clean
the machine housing with a soft cloth, preferably
after each use. Keep the ventilation slots free from
dust and dirt. If the dirt does not come off use a
soft cloth moistened with soapy water. Never use
Speed setting
solvents such as petrol, alcohol, ammonia water,
-
etc. These solvents may damage the plastic parts.
+
Please clean the tool immediately after use.
+ -
-
Lubrication
Make sure to lubricate the flexible shaft regularly
to prevent excessive heat generation.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
Speed setting
warranty card. In the back of this manual you find
+
an exploded view showing the parts that can be
+ -
ordered.
+
Speed setting
To prevent damage during transport, the
+ +
appliance is delivered in a solid packaging which
-
consists largely of reusable material. Therefore
+ -
please make use of options for recycling the
-
packaging.
Speed setting
Max
+ -
Only for EC countries
+ +
Do not dispose of power tools into domestic
-
waste. According to the European Guideline
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
ENVIRONMENT
Damaged and/or disposed of electrical
or electronic devices must be dropped
off at recycling stations intended for that
purpose.