Turning The Blade Bar; Storage; Waste Disposal And Environmental Protection - Parkside PGHSA 20-Li A1 Originalbetriebsanleitung

4. Mount chain bar (10), chainsaw (11)
and sprocket chain wheel covering (8)
and tighten the chainsaw.

Turning the blade bar

Use cut-resistant gloves when work-
ing with the saw chain or with the
blade bar.
The blade bar (10) needs to be reversed
regularly after a working time of about 10
hours in order to ensure even wear.
1. Switch off the device and remove the
battery (13) from the device.
2. Remove the sprocket cover (8), saw
chain (11) and blade bar (10).
3. Turn the blade bar around its horizon-
tal axis and install the blade bar and
chain as described under "Installing the
saw chain and blade bar".
When doing so, pay attention to the
correct rotation direction of the saw
chain!
Use the graphical symbol above the chain
sprocket (16) as a guide to align the saw
chain (11) when the blade bar is rotated.
The illustrated direction of travel on the
blade bar is no longer true.

Storage

• Clean the equipment before putting it
away.
• Put on saw bar protection sheath.
• Store the appliance in a dry place well
out of reach of children
Direction of travel of
saw chain
Waste disposal
and environmental
protection
Remove the battery from the device and re-
cycle the device, battery, accessories and
packaging in an environmentally-friendly
manner.
Electrical devices must not be dispo-
sed of with domestic waste. The
crossed out waste bin symbol means that
this device must not be disposed of with
household waste after its service life.
Do not throw batteries into domestic
waste, fi re (risk of explosion) or wa-
ter. Damaged batteries can harm the
environment and your health if poisonous
fumes or liquids escape.
• Do not dispose of used oil in the sew-
age system or drains. Dispose of used
oil in an environmentally correct man-
ner - bring it to a waste disposal center.
Directive 2012/19/EU on waste electrical
and electronic equipment: Consumers are
legally obliged to recycle electrical and
electronic equipment in an environmentally
sound manner at the end of its life. In this
way, environmentally friendly and resour-
ce-saving recycling is ensured.
Depending on the implementation in na-
tional law, you may have the following
options:
• Return to a shop,
• Hand over to an offi cial collection point,
• Return to the manufacturer/distributor.
This does not affect accessories enclosed
with the old devices or tools without any
electrical components.
GB
45